<noscript id="odh04"></noscript>
  • <form id="odh04"></form>
      <nav id="odh04"></nav>

      <em id="odh04"><source id="odh04"><dl id="odh04"></dl></source></em>

        <form id="odh04"><span id="odh04"></span></form>


        弯头技术要求Technical requirements of elbow

        1, as most of the pipe fittings are used for welding, in order to improve the welding quality, the end is all turning into a slope, leaving a certain angle and with a certain edge. This requirement is also strict, the edge is thick, the angle is as much as the range and the range of the deviation are all stipulated. The surface quality and mechanical properties are basically the same as those of pipes. For the convenience of welding, the fittings of the pipe and the connected pipe are the same.
        2, that is, all fittings must be treated by surface treatment. The oxide scales inside and outside are sprayed out by shot peening, and then coated with anticorrosive paint. This is for export needs. In addition, it is also for domestic transportation to prevent rust and oxidation.
        3, the requirements for the packaging for small pipes, such as the export, the need to do wooden cases, about 1 cubic meters, the number of bends in this box can not be more than one ton, the standard allows suit, that is, large sets, but the total weight is generally not more than 1 tons. For large y, a single package is required, like 24 ', which must be packed individually. Another is the packaging mark, marking is the size, the steel number, the batch number, the manufacturer trademark and so on.
        国产三级无码爽死你,国产色综合天天综合网,亚洲色无码专区一区,亚洲精品少妇30p <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <文本链> <文本链> <文本链> <文本链> <文本链> <文本链>